REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 323 (1985 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mazda
	323
		Introduction
		Gasoline engines
		Engine oil
		Engine cooling system
		Ignition system
		The power supply system, the carburettor, fuel injection system
		Diesel engine
		Exhaust
		Coupling
			Removal and installation / check clutch
			Removal and installation / check of clutch release bearing
			Adjustment of a pedal / clutch cable
			Check / adjust the clutch pedal
			Bleeding the clutch
		Manual gearbox
		Automatic Transmission
		Suspension and steering system
		Brakes
		Wheels and tires, a body, car coloring, care of the car
		Electrical system
		Heater, illumination system, devices
		Controls and operation receptions
		Electrical diagrams

printable version

Removal and installation / check of clutch release bearing

Withdrawal

PERFORMANCE ORDER

Remove the gearbox.

Cars up to 9/89 MY. and wagon models: Pull the lever return spring clutch on the gearbox casing and remove release bearing with the clutch fork.

Cars since 10/89 vol., Except wagon models: Remove the release bearing with the clutch fork and then remove the bearing. On all-wheel drive models with 1/90 MY. take into account the mounting position of the intermediate plate. See

Check

PERFORMANCE ORDER

Squeeze the release bearing and simultaneously turn. On vehicles with a 9/89 MY. Bearing stretch and rotate simultaneously. If the bearing rotates with difficulty, to install a new bearing.

The bearing has a long-term lubrication and should neither be cleaned nor greased.

Setting

PERFORMANCE ORDER

Lightly coat the contact surface on the release bearing and clutch fork lubricant _of MoS 2.

Attach the release bearing to the plug and insert the two elements in the shaft of a transmission.

On all-wheel drive models with 1/90 MY. between the fork and the clutch release bearing is a needle bearing, which makes it easier to bring the clutch action. Before installing a new release bearing rearrange both intermediate plates with the spring from the old to the new bearing.

Attach the cover clutch fork on the gearbox casing.
If so, attach the return spring release lever.

« previos page
Removal and installation / check clutch

next page »
Adjustment of a pedal / clutch cable