add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 626 (from 1991 to 1998, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Mazda 626
Home
 
Mazda
626
Instructions
Maintenance
Engines
Petrol engines (1,6 and 1,8 liters)
Gasoline 4-cylinder engine (2 liters)
Gasoline engine V6 (2,5 liters)
A partition of engines (1,6 and 1,8 liters)
Bulkhead engine (2.0 liters and 2.5 V6)
The diesel engine of 2.0 liters
Specifications
Maintenance and repair
The principle of operation of the diesel engine
Toothed belt, setting the valve timing
RF Engine
Front toothed belt
Rear toothed belt
Engine RF-N
System preheat
Checking device preheat
Removal of air from fuel system
Checking and replacing the fuel shut-off solenoid valve
Check and adjustment of turns of idling
Removal and installation of atomizers
Removing vacuum pump
Fault diagnosis of diesel engine power
Systems of an electric motor
Heating and ventilation
Fuel system
An exhaust system
Transmissions
Coupling and semiaxes
The brake system
Chassis
Body
Electrical
Wiring
Tips and Tricks
 


Hit Counter by Digits


print page printable version

Rear toothed belt



Withdrawal
PERFORMANCE ORDER

A warning

This clears the electronic storage device, such as a radio receiver code. Before disconnecting the battery, read the sub-section 2.11.


1. Disconnect the cable from the battery negative mass.
2. Remove the spark plugs.
3. In the forthcoming re-install the toothed belt zamarkiruyte it. It should be put on the belt prescriber arrow direction of rotation. The motor rotates clockwise.

Setting


A warning

Toothed belt bend or fold. Always replace contaminated, damaged or worn belts. Check the uniformity and ease of movement of the tension roller.


PERFORMANCE ORDER
1. To rotate the camshaft lift the front wheel of the car, set the 5th gear and turn the wheel by hand.

A warning

In no case did not turn the wheel of the camshaft to avoid overloading the front toothed belt.


2. Put the toothed belt. Upon application of an old belt overlay applied in accordance with direction arrows.

A warning

Make sure the belt is well covered wheels and does not sag.



Tension

PERFORMANCE ORDER
1. Loosen the bolt of a tension roller so that the roller can move to a gear belt under spring force.
2. Turn the crankshaft two turns clockwise until the alignment marks on the camshaft and on the back of the board. Once again, make sure that all the labels are the same.
3. Tighten the bolt tensioning pulley with a force of 25 Nm
4. Turn the crankshaft two turns in the direction of rotation of the engine and re-check the adjustment.
5. Check toothed belt tension. The length of the belt between the wheels of the water pump and camshaft should cave in on 9,5-12,0 mm from the efforts of a 10-kg (strong pressure with your finger), if it is not, loosen the bolt tensioner pulley and tighten the belt again.
6. Install and secure with a force of 10 Nm back casing of a gear belt.
7. Replace the spark plugs.
8. Connect the negative mass in the battery.
9. If there are clocks, set the time and set the security code radio.




« previos page
Front toothed belt
next page »
Engine RF-N

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.