| 1. Disconnect the cable from the battery negative mass. |
A warning  This clears the electronic storage device, such as a radio receiver code. Before disconnecting the battery, read the sub-section 2.11.
|
| 2. Lift the car and remove the right front wheel. |
| 3. Remove the bottom engine cover on the right wheel arch. |
| 4. Remove the V-belt. |
| 5. Lock the engine and unscrew the bolts of the crankshaft pulley. |
| 6. To disable the engine, set the 5th transfer and specify assistant depress the brake pedal. |
| 7. Remove the crankshaft pulley. |
 | 8. Remove the right and left casings of a gear belt. |
| 9. Remove the engine mount. |
| 10. Remove the spark plugs. |
| 11. Crank the engine crankshaft, tighten the hand brake, the transmission in neutral. Use the knob and turn the head of the wheel of the crankshaft from the right-hand wheel arch. |
A warning No way to turn a cranked shaft behind the wheel of a camshaft through a toothed belt drive to avoid overloading the toothed belt.
|
 | 12. In the upcoming re-installing the toothed belt zamarkiruyte it. It should be put on the belt prescriber arrow direction of rotation. The motor rotates clockwise. |
| 13. Remove the rim roller. |
| 14. Remove the timing belt. After the gears do not turn. |
A warning Before removing again to check that the label on the wheel of a camshaft with the edge of the cylinder head, correct if necessary. If necessary, check the camshaft at the removed gear belt, any piston should not be in the TDC. Otherwise, you may cause serious damage to the pistons and valves.
|
 | 15. Before applying the label, set the 1st cylinder TDC. To do this, turn the crankshaft to match the mark (1) on a camshaft cogwheel (2) with a label on the front board. Then, turn the wheel of the crankshaft 1/4 turn (90 ?�) to the left or right. The label must face is now the left or right. |
