1. Insert the plugs (38b) and (38c) through the holes in the steering wheel. |
| 2. Fit the steering wheel so that coincided marking the shaft and wheel. |
3. Screw the new self-locking bolt with countersunk head and tighten it to a torque of 80 Nm, while the assistant should hold the steering wheel. |
4. Place a block of the airbag. |
5. Make a test drive and when driving in a straight line, check the position of the steering wheel. The upper edge of the cross must stand horizontally. |
6. In the event that there is inclination shift can be one tooth attachment slots on the steering shaft. A warning If this displacement of the steering wheel is not enough, check convergence of the front wheels.
|
7. Make sure the reference indicator unit of the airbag at full turn of the steering wheel all the way in both directions with the engine running, check the radiator should not light up. |
8. Check the flashing light on and off the turn signal after the turn. A warning Dirty or sticky steering wheel can be cleaned with a neutral household cleaner and slightly warm water. Do not use abrasive wheels for cleaning powders or pastes.
|