REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz C-Class (W203, 2000 issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mercedes-Benz
	W203
		Introduction
		Instruction Manual
		Routine maintenance
		Engine
		Cooling and heating
		The power supply system and release
		Electric motor
			Ignition and engine control
			System of preheat of the diesel engine
			Diagnostics of systems of electronic control and diagnostic equipment
			Charge and start systems
				Battery - basic information and the acquisition of new battery
				Check the battery and charging
				Replacement Battery
				Storage Battery
				Charging System - general information and safety measures
				Check the charging system
				Removing and installing the generator
				Removing and installing voltage regulator. Replacement brush
				The system start the engine - the general information and precautions
				Removing and installing starter
				Removal and installation of the traction relay of a starter
				Checking the engine starting system
		Manual gearbox
		Automatic Transmission
		Coupling and power shafts
		Brakes
		Suspension and steering
		Body
		Onboard electric

printable version

Charge and start systems

All covered in this manual cars have an electrical system that operates with a voltage of 12 V. The connection passes through the mass of the negative terminal of the battery. The battery is in the trunk.

To start the engine using the starter motor. Starter switch is part of the ignition switch and turn on the turn-ons installed on the starter magnetic switch.

Built into the dashboard control light indicates charging perfect operation of electrical equipment until the battery is normal.

« previos page
Use of the oscilloscope to observe signals in chains of control systems

next page »
Battery - basic information and the acquisition of new battery