REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz C-Class (W203, 2000 issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mercedes-Benz
	W203
		Introduction
		Instruction Manual
		Routine maintenance
		Engine
		Cooling and heating
		The power supply system and release
		Electric motor
			Ignition and engine control
			System of preheat of the diesel engine
			Diagnostics of systems of electronic control and diagnostic equipment
			Charge and start systems
				Battery - basic information and the acquisition of new battery
				Check the battery and charging
				Replacement Battery
				Storage Battery
				Charging System - general information and safety measures
				Check the charging system
				Removing and installing the generator
				Removing and installing voltage regulator. Replacement brush
				The system start the engine - the general information and precautions
				Removing and installing starter
				Removal and installation of the traction relay of a starter
				Checking the engine starting system
		Manual gearbox
		Automatic Transmission
		Coupling and power shafts
		Brakes
		Suspension and steering
		Body
		Onboard electric

printable version

Removing and installing starter

To start the internal combustion engine needs an electric motor, called a starter. To drive a car to work, you must unleash it to a speed of 300 rev / min. This can be achieved if the starter works reliably and the battery is charged.

So how to start the engine requires a large power consumption during maintenance should pay attention to the reliable connection cables. Contact with rust should be cleaned and lubricated with grease.

Withdrawal

PERFORMANCE ORDER

1. Disconnect the negative (-) cable of the battery when the ignition vyklyuch?�nnom. You must first remove the air filter box of the passenger compartment.
Before disconnecting the cable, find out the radio security code, if any, address to Section Replacement of the battery.

Do not connect an auxiliary power supply.

2. Lift and establish on supports a forward part of the vehicle.
Operation lifting and car installation on supports is connected with danger! Therefore, prior to the operation to check out the Poddomkrachivanie and towing Introduction to management.

3. Remove the bottom, refer to Section Removal and installation of the engine compartment lid from the bottom.
4. Engine 112: Remove the exhaust system.

5. Remove the nuts (1) and disconnect the electric wires from the starter.

6. Remove the 2 screws (2) on the starter.
7. Move aside the cable harness with the holder down and remove the starter from the engine compartment.

« previos page
The system start the engine - the general information and precautions

next page »
Removal and installation of the traction relay of a starter