Removing and installing voltage regulator. Replacement brush

1. Remove the generator refer to the appropriate section.
2. Remove the nuts on the terminals.

3. Remove the screws (1) and remove the protective cover from the generator (2), spreading with the locking plate (3). Depending on the model, the engine may be installed generators of various capacities.

4. Remove the screws (4) and remove the side knob (5). (6) - joining the masses.
5. Replace the brushes, which Unsolder cables.
6. Check the wear of contact rings, if necessary pierce them and polish (work HUNDRED).

1. Insert the new brushes () and springs (B) in brush holder (C) and solder them. Illustration is only informative, and can not fully comply with this model.

2. To exclude getting into the solder for soldering the new brushes, pliers hold the cables.

Solder leads to hardening of the ropes, which makes them not operational.

3. Fit the pressure regulator.
4. After installing the new brushes check the ease of travel to the brush holder.
5. Secure the generator protective cover.
6. Secure the nuts on the terminals.
7. Set the generator refer to the appropriate section.