add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz G-Class (W463, 1999 issue)

general info. full specifications. diagnostics. hints. tips. tricks
Mercedes-Benz G-class
Home
 
Mercedes-Benz
G-class
Introduction
Controls and operation receptions
Current care and maintenance
Engine
System of cooling, heating, ventilation and air conditioning
Engine cooling system
Ventilation systems, heating and air conditioning
General information and safety measures
Removal and installation of the control panel operation of the heating / ventilation / air conditioning
Removal and installation of the cabin filter
Removal and installation of the fan heater / air conditioner and control module
Removing and installing heat exchanger heater
Removal and installation of the circulating pump heating
Removing and installing rear ventilation flaps
Check the coolant level in the working path of the system K / V
Removal and installation of gauges of system K / V
Removal and installation of auxiliary fan assembly
Removal and installation of the motor drive ventilation flap
Removal and installation of the stepper motor drive mode switching valve air circulation
Removal and installation of an electric motor drive the mixing flap
Removal and installation of evaporator K / V and housing
Removal and installation of compressor K / V
Removing and installing condenser K / V
Removal and installation of the expansion valve
Removal and installation of receiver-dryer
The power supply system and exhaust
Systems of an electric motor
Automatic Transmission
Transmission Line
Brakes and auxiliary systems
Suspension and steering
Body
Onboard electric
Wiring
 


Hit Counter by Digits


print page printable version

Removal and installation of the expansion valve



All sealing elements are subject to replacement without fail!

Details setting of the expansion valve
9 - Bolts
10 - Expansion Valve
11 - Gasket

PERFORMANCE ORDER

  1. Remove the cover of the evaporator (see. Section Removal and installation of evaporator K / V and its casing).
  2. Remove the gasket (11), - if necessary, prepare a removable sealing member.
  3. Remove the fixing bolts (9) and remove expansion valve (10).
  4. Installation is in the reverse order.
  5. Finally, make sure of serviceability of functioning of system K / V.





« previos page
Removing and installing condenser K / V
next page »
Removal and installation of receiver-dryer

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.