| - To test requires a pressure gauge which can be screwed into the hole D / oil pressure disposed above the fuel filter.
|
- Check and adjust the level of motor oil (see chap. Adjustment and car routine maintenance).
- Warm up the engine and let it run at idle speed, the fan is turned on and the radiator turned off again.
- Remove the oil filter, remove the D / motor oil pressure and screw in its place the gauge. Install the fuel filter.
- Start the engine and compare the pressure gauge with the requirements of the Specifications at different speeds of the crankshaft.
- If the specified value is not achieved, check the motor (could be damaged, for example, the main bearings of the crankshaft), or replace pressure relief valve or oil pump.
- After checking with the installation D / Pressure motor oil is used for a new O-ring and thread with sealant. Tighten the A / B with the required effort.
|
|