 printable version
Removal and installation of assemblage of the mechanism off the rear stabilizer lateral stability
Withdrawal Components of a drive off the back stabilizer of transverse stability  | |
| - Poddomkratte back of the car and establish it on props, the institution under the axle housing. Turn the control knob disconnecting stabilizer lateral stability in the "on" position.
- Give a nut of the spherical hinge of the right rack stabilizer lateral stability and remove the rack from the bar.
- Disconnect an electric socket of a control lamp.
- Remove the front drive cable from the back on the controller. Using pliers, remove the retaining plate on the cable adjuster bracket.
- Give tightening bolts cable and release the bolts of the assembly. Remove the assembly off the anti-roll stability from under the car.
- If necessary, remove the front-drive cable from the control handle, as follows:
- Give tightening bolts cable to the vehicle chassis.
- Give nuts securing the control handle to the bulkhead.
- Remove the bolt handle to the instrument panel, remove the handle with a rope from the car.
- Check the assembly off the anti-roll stability for signs of damage. Tried the drive cable assembly by hand, checking serviceability disable stabilizer. When you release the cable rack must firmly locked in the assembly. If necessary, replace.
|
|
Setting Installation is in the reverse order. | - Adjust the length of the cable, ensuring the value of the freewheel in 0.2 ÷ 0.7 mm.
- Make sure of reliability of fastening of the connector control lamp.
|
|
|
