printable version
Kick-down - switch - adjustment
1. The switch is designed to supply power to the solenoid drive downshift by pressing a pedal throttle to failure. If the switch is not adjusted, the downshifting occurs at partial throttle.
| 4.3 Typical Connection kick-down - switch |
| 5.4 Adjust the stem of the vacuum diaphragm 1. Saddle (valve should be pressed against the valve seat) 2. The wall of the crankcase Z.Shtok 4. Plate housing 5. throttle valve throttle valve |
2. Turn on the ignition and press the throttle pedal to failure - in this case should be heard a click. 3. If there is no click, then release the lock nut (switch mounted on the pedal), press the pedal to failure and apply the switch until it clicks (with emphasis to the pin). 4. Tighten the lock nut and check the adjustment. 5. If the switch is adjusted, but downshifting does not occur, check the closure of the switch contacts and the presence of voltage on it. 6. If the voltage is present and contacts closed, contact the service center to check the circuit switch and solenoid actuator.
|