REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Golf II, Jetta (from 1983 to 1992, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Volkswagen
	Golf 2 / Jetta
		General Information
		Engine
		The power supply system
		Coupling
		Transmission
		Transmission
		Front-wheel Drive
		A steering
		Suspension
		Brakes
		Body
		Electrical
			Fuse and Relay
			Generator
			Starter
			Headlight
			Replacing the front turn signal lamp
			Replacement of lamps of a back lantern
			Changing the light bulb license plate
			Windscreen wiper
			Wipers Tailgate
			Adjustment of a jet of washers of glasses
			Device combination
			Power indicator lights
			Ignition system
				Classical ignition system
					Removal and installation of the distributor of ignition
					Check breaker contacts
					Replacement of contacts of the breaker
					Check and adjust the angle of the closed state of the contacts
					Adjusting the gap between the contacts
					Adjust the ignition timing
					Visit the distributor cap
					Check centrifugal regulator ignition distributor
					Check the vacuum-proof-reader of the distributor of ignition
					Check the ignition coil
					Check spark plugs
				Transistor ignition system
			Electrical circuits

printable version

Check and adjust the angle of the closed state of the contacts

Corner of the closed condition of contacts (UZSK) is checked by means of a special device. UZSK should be within 47 ?� ?� 3 ?�. If it is different, it has to be adjusted, which should loosen the screws securing the fixed contact, insert a screwdriver into the slot and the fixed contact, turning it thereby averting or summarizing the fixed contact to the movable, adjust UZSK as indicated by the device. Tighten the screws that secure the fixed contact. If there is no special device to adjust UZSK, you can adjust the gap between the contacts.

« previos page
Replacement of contacts of the breaker

next page »
Adjusting the gap between the contacts