printable version
Countershaft
Remove the intermediate shaft is possible only when the engine is removed from the vehicle. Flange mounting of the intermediate shaft has a back side and the oil passage may be installed in only one position. The maximum axial clearance of the intermediate shaft is 0.25 mm; If the gap is greater, replace the flange. Removal and installation of an intermediate shaft is similar to the removal and installation of shaft at engines in working volume of 1,6 and 1,8 l (see. Subsection 2.2.2.6). Tightening torque pulley bolt to an intermediate shaft 45 Nm (4.5 kgf-m). When installing a new pulley on the engine before the release of January 1984 should be a clearance of 0.5 mm (see. Fig. The gap between the pulley and the intermediate shaft bracket high pressure fuel pump).
|