add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Sharan (from 1995 to 2000, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Volkswagen Sharan
Home
 
Volkswagen
Sharan
Introduction
VR6 engine
The two-liter engine (ADY)
Engine oil
Cooling
A fuel injection system VR6 engine
The system Simos injection 2.0-liter engine
The ignition system
Coupling
Manual 5-speed gearbox
The drive shafts
Power steering
Front suspension
Rear suspension
Brakes
Electrical
Accumulator battery
Generator
Starter
Wipers
Headlights
Replacing bulbs Headlight
Removing and installing lights
Disassembly and assembly of lights
Adjusting headlights
Rear lights
Replacement lamps front indicators
Diesel engine
The lubrication system of the diesel engine
The cooling system of the diesel engine
The power supply system of the diesel engine and turbocharger
Map service.
Applications
Wiring
 


Hit Counter by Digits


print page printable version

Replacing bulbs Headlight



Headlamp washers removed from the engine compartment of the motor. Replacing the lamp does not change the alignment of lights.

A warning
When replacing headlight bulbs use gloves to the glass bulb left fat fingerprints, as even slight traces of fat on the burning lamp lead to the darkening of the bulb and rapid lamp failure. If such evidence is, remove them with alcohol.

Replacing the headlight bulb is held in the following order:

View the back of the headlight
Fig. 351. View of the back of the headlight 1 - a clip; 2 - an electric socket; 3 - marker lamp bulb holder; 4 - lamp lights; 5 - lock clamp




Individual elements lights
Fig. 350. Individual elements of Lights: 1 - screw 8 Nm; 2 - locking clip; 3 - the lamp housing; 4 - the ventilation device; 5 - a cover; 6 - side light bulb holder; 7 - double-stranded Lamp, H4; 8 - incandescent lamp of dimensional light; 9 - a reflector; 10 - rubber gasket; 11 - headlamp lens; 12 - the screw fastening; 13 - the motor that rotates the reflector lights




- Remove from the engine compartment protective cover 5 (see. Fig. 350). To do this, turn the cover to the left and remove it. Now the spotlight has the form shown in Fig. 351;
- Disconnect the electrical connector 2 on the rear side lights;
- Click on the lock 5 clamps 1 and fold down the clip;
- Remove the headlamp bulb 4;
- Install a new lamp (use gloves). When installing the lamp, "tabs" on the lamp cap should enter into the grooves on the reflector;
- Put the clamp 1 on the lamp base and snap the latch 5;
- Put on the lid and turn it clockwise.
After replacing the lamp lights, check and, if necessary, make adjustments headlights. We recommend adjusted on the SRT.
Replacing the side light bulb
Replacing the side light bulb held in the following order:
- Remove from the engine compartment protective cover;
- Remove the cartridge 3 (see. Fig. 351) with a lamp of dimensional light and plug strip of the lamp housing;
- Replace defective lamp cartridge and slide the new lamp and plug strip in the reflector;
- Put the protective cover and turn it clockwise.




« previos page
Headlights
next page »
Removing and installing lights

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.