add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Elantra (from 2000 to 2004, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Hyundai Elantra
Home
 
Hyundai
Elantra
Gasoline engines 1.6, 1.8 and 2.0 liters
The diesel engine of 2.0 liters
Greasing system
Cooling
Fuel system
Control systems and emission control
Ignition system
The system of preliminary heating of the diesel engine
Coupling
Manual transmission
Automatic Transmission
Technical data
Check the fluid level in automatic transmission
Substitution fluid in an automatic transmission
Check conduction switch the transmission range (F4A42)
Switch the transmission range and adjustment of the control cable (F4A42)
Check the operation of the selector lever (A4AF3)
Adjustment of the switch indicate the position of the selector lever (A4AF3)
Component testing of an automatic transmission (F4A42)
Testing of teamwork of an automatic transmission and the engine for the motionless car (F4A42)
Check the transmission fluid pressure (F4A42)
Check the transmission fluid pressure (A4AF3)
The diagnostic function
Diagnostic codes
Adjustment of an axial backlash reaction brake (F4A42)
Adjusting the axial clearance of the brake of the second transmission (F4A42)
Adjusting the axial clearance of the brake transmission and low reverse gear (F4A42)
Adjusting the axial clearance of the sun gear downshift (F4A42)
Adjusting the preload of the differential (F4A42)
Elements of hydraulic control system
Identification of bearing automatic transmission F4A42
The control lamp fault (MIL)
Identification of bearing automatic transmission F4A43
Adjusting the servo compulsory inclusion downshift (A4AF3)
Adjust the line pressure (A4AF3)
Replacement of an oil sealing ring of a power shaft
Removing and installing transmission F4A42
Removing and installing transmission A4AF3
Control automatic transmission
Installing the locking device
Installing a locking key
Drive shafts, front and rear axles
Suspension
Steering
Brakes
Body
The air conditioning system
Electrical equipment
Electrical diagrams
 


Hit Counter by Digits


print page printable version

Substitution fluid in an automatic transmission



If replacement of the fluid in the torque converter, and replace the fluid in the transmission. If the replacement fluid in the torque converter is not carried out, replace the fluid in the gearbox follows.

PERFORMANCE ORDER

  1. Disconnect the hose, which connects the transmission and the oil cooler (radiator side). Remove the drain plug from the bottom of the gearbox and drain the liquid.
  2. Install the drain plug gasket and tighten the torque given in the specification. Torque: 32 N ??? m.
  3. Pour the required amount of liquid required.

Stop fill liquid if desired amount can not be filled in the gearbox.

  1. If you have filled in more of the transmission fluid, repeat the procedure in accordance with step 1.
  2. Connect the hose which was disconnected in step (1) and firmly insert the dipstick.
  3. Start the engine and let it run for 1-2 minutes at idling speed.
  4. With the engine running, move the selector lever out of position ?�N?� to all positions and back into position ?�N?�.
  5. Take a trip to a warm-up transmission to temperature 70-80 ?� C. Park the car on a level surface. Check the fluid level, which should be between labels ?�HOT?�. If necessary, add the required amount of liquid required.
  1. Firmly insert the dipstick transmission fluid.





« previos page
Check the fluid level in automatic transmission
next page »
Check conduction switch the transmission range (F4A42)

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.