add to favorites

REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Matrix (2002 and 2006 model year)

general info. full specifications. diagnostics. hints. tips. tricks

Hyundai Matrix

Home

Hyundai
	Matrix
		Operation and maintenance of car
		Engine
		Transmission
		Chassis
		Steering Gear
		Brakes
			Overview
				Checking and adjusting the brake pedal
				Check the operation of the brake servo without tester
				Removal of air from hydraulic brakes
				Check and adjust handbrake lever stroke
				Removing and installing brake servo
				Check the brake system of highways
				Removing and installing brake pedal
				Removal, check and installation of the front brake pads
				Dismantling, check and assemblage of the brake caliper
				Disassembly, inspection, assembly and installation of the main brake cylinder
				Pressure regulator rear brakes
				Removal, check and installation of the rear drum brakes
				Replacing the working brake cylinder
				Removal, check and installation of the parking brake
				Anti-lock brakes (ABS)
				Removal and installation of the electronic ABS control unit
				Removal and check wheel speed sensor (ABS)
			Tables
		Onboard electric
		Body
		diagrams

Hit Counter by Digits

printable version

Removal and check wheel speed sensor (ABS)

Location wheel speed sensor ABS

Fig. 6.70. Location wheel speed sensor ABS

Withdrawal

Bolt sensor

Fig. 6.71. Bolt sensor

Remove the bolt wheel speed sensor (Fig. 6.71).

Connector wheel speed sensor

Fig. 6.72. Connector wheel speed sensor

Disconnect the connector wheel speed sensor and remove the sensor (Fig. 6.72).

Removing the speed sensor of the rear wheel

Remove the rear seat cushion.

Wall plate-pillar

Fig. 6.73. Wall plate-pillar

Remove the trim plate-pillar (Fig. 6.73).

Remove the wheel.

Removing the sensor

Fig. 6.74. Removing the sensor

Disconnect the connector and remove the sensor (Fig. 6.74).

Check

Measuring the resistance between the sensor terminals

Fig. 6.75. Measuring the resistance between the sensor terminals

Measure the resistance between the sensor (Fig. 6.75).

Rated resistance:

- Speed sensor front wheel - 1275-1495 Ohm.

- Speed sensor rear wheel - 1275-1495 Ohm.

Measure resistance between sensor terminals while rotating the wheel

Fig. 6.76. Measure resistance between sensor terminals while rotating the wheel

When you rotate the wheel, measure the voltage between the terminals of the sensor (Fig. 6.76).

Nominal value: recorded AC voltage.

NOTE

Set the voltmeter to measure AC voltage (AC voltage).

« previos page
Removal and installation of the electronic ABS control unit

next page »
Tables

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.