REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Jeep Grand Cherokee (from 1993 to 1999, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Jeep
	Grand Cherokee
		Introduction
		Adjustment and routine maintenance
		The straight six-cylinder engine
		The V8 engine
		Procedure of the general and engine major repairs
		Systems of cooling, heating and air conditioning
		The power supply system and exhaust
		The system of electric motor
		Systems of decrease in toxicity of the fulfilled gases and engine management
		Manual box of a gear change
		Automatic Transmission
		Transfer Case
		Clutch and transmission line
		Brakes
			general information
			Anti-lock braking system (ABS) - the general information
			Replacing disc brake pads
			Removal, major repairs and installation of supports of disk brake
			Condition check, removal and installation of a brake disk
			Replacement of boots of drum brake
			Removal, major repairs and installation of wheel cylinders
			Removing and installing the combined valve (regulator)
			Removal and installation of the main brake cylinder
			Check and replacement of brake hoses and lines
			Bleeding brake system
			Functioning check, removal and installation of the vacuum brake booster
			Check operation, removal, installation and adjustment of the gauge-switch of stoplights
			Adjusting the parking brake
			Replacing the parking brake cable
			Replacement of boots of a lay brake (disc brakes rear wheels)
		Suspension and steering
		Body
		The system of on-board electrical equipment
		Controls and operation receptions

Brakes

Specifications

Common parameters

The type of fluid

Disc brakes

Minimum permissible thickness of the brake disc	Stamped or cast on the body of the disc
The maximum permissible fluctuations disc thickness (mm)
Front brake disc	No more than 0,013 mm
Disc rear brake	No more than 0,025 mm
Maximum allowable runout disc (mm)	0.13
Minimum permissible thickness of the brake pads	See. Chapter Settings and maintenance

Drum brakes

The maximum diameter of the drum	Stamped or cast on the body of the drum
The minimum admissible thickness of frictional overlays of brake boots	See. Chapter Settings and maintenance

Efforts of a tightening of carving connections, N ??? m

Nuts of fastening of the vacuum amplifier of brakes	41
Nuts of fastening of the main brake cylinder	13.0 - 24.9
Fixing pins brake caliper (front and rear)	9.5 - 20.3
The hollow bolt of the brake hose to the caliper brake (front and rear brakes)	31
Bolts wheel cylinders	10.2