add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Jeep Grand Cherokee (from 1993 to 1999, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Jeep Grand Cherokee
Home
 
Jeep
Grand Cherokee
Introduction
Adjustment and routine maintenance
The straight six-cylinder engine
The V8 engine
Procedure of the general and engine major repairs
Systems of cooling, heating and air conditioning
The power supply system and exhaust
The system of electric motor
Systems of decrease in toxicity of the fulfilled gases and engine management
Manual box of a gear change
Automatic Transmission
Transfer Case
Clutch and transmission line
general information
Clutch - a general description and check of serviceability of functioning
Removal and installation of components of the hydraulic clutch system
Removal, check of a condition and installation of components of the clutch
Removal, check of a condition and installation of the clutch release bearing
Check and replacement of the directing bearing
Cardan shafts, differentials and bridges - general information
Checking the status of the transmission line
Removing and installing drive shafts
Replacing the universal joints
Replacing the oil seal differential pinion shaft
Removal, service and installation of the hub and bearings (front wheel)
Removal, major repairs and installation of the front drive shaft
Removal and installation of the front axle assembly
Removing and installing the rear axis and bearing assembly
Removing and installing rear axle assembly
Brakes
Suspension and steering
Body
The system of on-board electrical equipment
Controls and operation receptions
 


Hit Counter by Digits


print page printable version

Removing and installing rear axle assembly



PERFORMANCE ORDER

  1. Loosen the nuts of the rear wheels, Poddomkratte car and establish it on props. Remove the wheels.
  2. Support the rear axle assembly trolley jack, lodged under the differential.
  3. Give the lower shock absorber mounting nuts, tighten the shock, remove them from the path (Head Suspension and steering).
  4. Disconnect the propeller shaft from the holder crosses a differential pinion shaft and hang it to the bottom of the back of the car with a piece of wire (Section Checking the status of the transmission line).
  5. Otboltite anti-roll bar on the stability of the link stabilizer (if available).
  6. Remove the parking brake cables from the equalizer (Head Brake system). Remove the stem of the valve control proportsioniruyuschego height sensor on the axle (only for Comanche).
  7. Disconnect the flexible brake hose from tee at the rear axle housing. Plug the end of the hose, or wrap it with a plastic bag to prevent loss of liquid and hit in dirt system.
  8. Secure the coil springs a safety chain in order to avoid formation flying spring after lowering the bridge.
  9. Lower the jack and remove the axle assembly from under the vehicle.
  10. Install in reverse order. Make sure that the nuts U-bolts and bolts of the universal joint yokes are tightened with demanded effort.




« previos page
Removing and installing the rear axis and bearing assembly
next page »
Brakes

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.