REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Jeep Grand Cherokee (from 1993 to 1999, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Jeep
	Grand Cherokee
		Introduction
		Adjustment and routine maintenance
		The straight six-cylinder engine
		The V8 engine
		Procedure of the general and engine major repairs
		Systems of cooling, heating and air conditioning
		The power supply system and exhaust
		The system of electric motor
		Systems of decrease in toxicity of the fulfilled gases and engine management
		Manual box of a gear change
		Automatic Transmission
		Transfer Case
		Clutch and transmission line
		Brakes
		Suspension and steering
			general information
			Removing and installing front stabilizer lateral stability and bushings
			Removal and installation of the front shock absorbers
			Removal and installation of the transverse jet bar front suspension
			Removal and installation of the front suspension arms
			Removing and installing coil spring front suspension
			Removing and installing steering knuckle
			Replacement ball joints
			Removing and installing rear stabilizer rod transverse stability
			Removing and installing the rear shock absorbers
			Removal and installation of the transverse jet bar rear suspension
			Removal and installation of levers of a back suspension
			Removing and installing coil spring rear suspension
			Removing and installing steering wheel
			Condition check, removal and installation of steering gear
			Removal and installation of the steering mechanism
			Removal and installation of the pump system hydrostrengthening steering
			Bleeding the steering system hydrostrengthening
			Wheels and tires - general information
			Corners of installation of forward wheels - the general information
		Body
		The system of on-board electrical equipment
		Controls and operation receptions

printable version

Removing and installing the rear shock absorbers

PERFORMANCE ORDER

Poddomkratte back of the car and establish it on props.
Support the rear axle assembly trolley jack, lodged under the differential. Cock jack enough to remove the shock absorber forces developed by the springs (shock absorbers serve to limit suspension travel down).
Give the bolt and nut lower strut.

To remove the lower end of the rear shock absorber bracket axle sleeves give the nut and bolt.

Remove the nut and washer upper strut shock absorber and remove the ear with the mounting studs.

Details of installation of the shock absorber and coil spring.

To remove the upper end of the rear shock absorber from the car give this nut, remove the washer and pull the ear damper with mounting studs.

Install in reverse order. All fixture tighten with demanded effort.

« previos page
Removing and installing rear stabilizer rod transverse stability

next page »
Removal and installation of the transverse jet bar rear suspension