| 1. Using a knife carefully align the seal on the body. Leave layer thickness of about 1-2 mm. |
A warning In the case of pitting old seal seal the new seal these places.
|
2. Thoroughly clean and remove any grease in the area of 5 cm around the perimeter of the glass and the adhesive remaining on the body. |
| 3. Glue the trim around the perimeter of the glass at a distance of 7 mm from the edge. |
A warning Firmly stick the pad and let it dry.
|
| 4. Using a brush, apply a primer on the perimeter of the glass and the body and allow it to dry for 20-30 minutes. |
A warning Avoid contact surfaces primed with dirt, water, oil and so on. D., And do not touch them with your hands.
|
| 5. Install the spacer in the position shown in the figure. |
A warning Replace any broken clips with new ones.
|
6. When the primer is dry, apply using a syringe to seal roller repair sealant thickness of 11 mm at a width of 7 mm on the outer side of the glass. |
| A warning Cut the nozzle of the cartridge repair sealant as shown in the figure.
If necessary, smooth the repair sealant to correct any irregularities.
|
| 7. Attach the rear window to the body. |
A warning In order not to expose the rear window of the pressure in the event of an abrupt closing of the door, keep the door window open until repair sealant has cured sufficiently.
Combine labels on glass with V-shaped grooves on the spacers.
The curing time of the repair seal At 20 ?� C Curing time surface: 1:00 The time required before the start of operation of the vehicle: 4:00 At a temperature of 35 ?� C Time hardening the surface for 10 minutes. The time required before the start of operation of the car: 2 hours
|
| |
| 8. If necessary, remove any excess, or add a repair sealant. |
| 9. Check for water leaks. Upon detection of a leak is well wipe the water and add a repair sealant. |
10. After checking for leaks of water Refit the upper rear door frame, rear rack and a rear luggage rack. |
| 11. Connect the rear window defogger. |