1. Install the door.
- Install properly on a car door
- Screw bolts of both hinges.
Torque: 13-26 N ??? m
2. Install the door seal the moisture.
3. Screw the stop bolt opening the door to the body.
Torque: 17-22 N ??? m
4. Install the wiring harness.
- Insert the wiring harness through the hole in the inner door panel.
- Fasten harness connectors to the door frame
5. Install the glass run.
- Refit the glass through the opening in the inner door panel.
- Fix the glass with two bolts.
6. Install the outside door handle.
- Install the outside door handle through the opening in the inner door panel in the initial position.
- Replace the two screws on the outside door handles.
Torque: 7-11 N ??? m
7. Install the door lock.
- Install the door lock through the opening in the inner door panel.
- Secure the door lock with three screws.
Torque: 8-11 N ??? m
- Connect to the modulator door lock
- Screw the two mounting nuts modulator door lock.
- Connect craving for outside door handle.
8. Install windows.
- Install the window regulator through the opening in the inner door panel.
- Secure windows seven nuts.
- Connect the window motor electrical connector.
11. Install the glass.
- Insert the outside of the door at first a forward part of the glass, and then, turning and lowering, set the glass on the door and place it on the bracket window. Screw, but do not lock the two screws on glass.
- Reconnect the power window control switch.
- Attach the wire to the negative terminal of the battery.
- Turn on the ignition and move the window up and down to activate the window control.
- If necessary, adjust the position of the glass.
- Switch off the ignition.
- Disconnect the power window control switch.
- Disconnect the negative battery terminal.
- Tighten the two screws on the glass to the window regulator.
Torque: 8-12 N ??? m
10. Establish directing sealant glass. For ease of installation, use soapy water.
11. Install the outer moisture proof strip and the door trim.
- Secure the outer moisture proof strip on the outside of the door.
- Replace the three screws that secure the decorative overlay door.
12. Install the door pylevlagozaschitnuyu film.
- Secure pylevlagozaschitnuyu film on the door.
- Output wiring harness electrical connector door.
- Output pull of the internal handle of opening of the door lock pylevlagozaschitnoy film.
13. Establish an arm of the handle and secure it with two screws.
14. Install the inside door handle.
- Secure the handle with two screws.
- Connect to handle two thrust the door lock.
15. Install the door trim.
- Connect the electrical connector.
- Refit the door trim.
- Install the cover on the left side of the door trim and secure it with two screws.
- Screw one screw securing the right side of the door trim.
16. Screw one screw bracket handle.
17. Replace the cover of the internal handle of the door.
- Install the inside door handle cap.
- One screw fix cover the inside door handle.
18. Install the door trim.
19. Connect the cable to the negative terminal of the battery.