The instrument cluster is located and tax electric speedometer counters daily and total mileage of the car, analog gauges fuel and coolant temperature and warning lights Information Center / warnings.
Warning lights warn following.
- Low engine oil pressure.
- Disabling anti-lock brake system (ABS).
- The presence of faults in the engine (MIL).
- Included rear window heater.
- Low brake fluid level.
- No battery charging.
- Not wearing a seat belt driver.
- The headlight of headlights.
- Do not shut one of the doors of the car.
- Apply the parking brake.
- Display airbags.
- Additional indicator (ACC).
- Low levels of fuel in the fuel tank.
- On indicator of hazard warning lights.
- Power indicator turn.
Electrical connection of the instrument cluster are located on the rear side of the body of the instrument cluster, which can be removed after pulling out the instrument cluster of the instrument panel. The printed circuit board carries out the connection between the connector and the instruments and warning lights and the instrument cluster is mounted on the rear of the instrument cluster. Incandescent lamp holders are installed in a printed circuit board with the back side of the instrument cluster. Pointers can be removed after removing the dash, trim and glass with a dash. When the ignition is checked warning lights dash.
Coolant temperature gauge is located in the instrument cluster shows the temperature when the ignition key is in the ?«ON?». A temperature sensor mounted on the motor changes its resistance depending on the temperature.
The fuel gauge
Electric Fuel level measurement system consists of a fuel level indicator, fuel level sensor located in the fuel tank and connecting wires. The fuel gauge is located in the instrument cluster and shows the fuel level when the ignition key is in the ?«ON?». When you turn the ignition switch to ?«ACC?» or ?«LOCK?» fuel gauge is not working.
Speedometer indicates a vehicle speed at a given time. Speedometer drive and counters daily and total mileage of the car by a motor based on the information from the sensors.
The tachometer indicates engine speed in RPM. Electronic unit tachometer measures the number of pulses generated by the ignition module and converts them into RPM.
When removing or installing any electrical unit, disconnect the wire from the negative terminal of the battery to prevent short circuits that can damage electrical appliances and circuits.
Rear window defroster switch
The switch includes a rear window defogger and defrost glass indicates that thawing is carried out.
Switch hazard warning lights
Switch hazard warning system includes all the turn signals, while also incorporating the turn indicators flash in the instrument cluster.
Wiper switch controls the windshield wiper.
Warning lights ?«ACC?»
Additional warning lights ?«ACC?» Lights when the radio is turned on or other user, and the ignition key is in the ?«ACC?».
The control lamp ?«ABS?»
The indicator lamp antilock brakes (ABS) illuminates when the ABS control unit detects a failure in the anti-lock brakes.
The indicator lamp low brake fluid level
The control lamp ?«BRAKE?» lights up when the brake fluid is lowered below the safety level, and the ignition key is in the ?«ON?». Brake fluid level sensor located in popolnitelnom tank of brake system. Float at low brake fluid level, dropping, electrical circuit, causing the warning lamp.
The warning lamp battery charging
The control lamp ?«CHARGE?» red lights when the ignition is switched on and should go out immediately after starting the engine. If the lamp lights when the engine is running, then the alternator is not charging the battery.
Control lamp of a failure in the engine
The control lamp ?«CHECK ENGINE?» lights up when the ignition is switched on and should go out immediately after starting the engine. If the lamp lights when the engine is running, then the engine control unit detects a fault.
The indicator lamp door is open
Burning warning lamp ?«DOOR?» indicates that one of the car doors are not closed.
The control lamp of pressure of oil
The control lamp ?«OIL?» lights up when the ignition is switched on and should go out immediately after starting the engine. If the lamp lights or flashes when the engine is running, it means that the pressure of the oil to lubricate the engine is not enough.
The indicator lamp beam
The indicator lamp beam headlights lit when the engine is running and when the driving beam.
The control lamp of a reserve of fuel
The control lamp of a reserve of fuel in the tank indicates that there is not much in the tank of fuel and the car must be as fast as possible to fill.
The control lamp of a lay brake
The indicator lamp lights when the parking brake parking brake is applied and the ignition switched on.
The indicator lamp rear window defogger
The control lamp ?«R - DEF?» rear screen indicates that the rear window heater is working.
The control lamp of seat belts
The control lamp ?«BELTS?» lights up and a buzzer sounds when the ignition is not fastened and the front seat belts.
The indicator lamp turning
The warning lamp turn signal is synchronized with the turn signal lamps.
Do not touch the glass or scales pointer fingers, as this will remain visible fingerprints.
When removing the instrument cluster trim, be careful not to scratch the glass on the instrument cluster and instrument cluster trim.
1. Remove the three screws that secure the finish of the instrument cluster.
2. Remove the four screws.
3. Pull the instrument cluster of the instrument panel.
4. Disconnect the two connectors from the instrument cluster.
5. Remove the instrument cluster.
Check the instrument cluster for damage and, if necessary, replace the damaged item.
1. Install the instrument cluster to the dashboard.
2. Connect the two connectors to the instrument cluster.
3. Insert the instrument cluster in the dashboard.
4. Replace the four screws that secure the instrument cluster.
5. Replace trim dash and secure it with three screws.