1. Place the door in the following order: a. set properly on the car door; b. screw bolts of both hinges. Torque: 17-29 N ??? m |
2. Install the door seal the moisture. |
3. Screw the stop bolt opening the door to the body.
Torque: 22-27 N ??? m |
4. Install the wiring harness in the following order: a. Insert the wiring harness through the hole in the inner door panel; b. secure five harness connector to the door frame. |
5. Install the outside rearview mirror as follows: a. Install the outside rearview mirror on the door to its original position; b. attach the mirror with three screws; c. Connect the electrical connector. |
| 6. Install the door lock in the following order: a. Install the door lock through the opening in the inner door panel; b. secure door lock with three screws.
Tightening torque: 4-6 N ??? m |
| 7. Install the outside door handle in the following order: a. Connect the two rod door lock; b. fix two bolts outside door handle. |
| 8. Install the glass run in the following order: a. Install the glass through the opening in the inner door panel; b. fix a bolt directing glasses. Torque: 9-13 N ??? m |
9. Install the guide sealing glass. For lubrication during installation, use soapy water. |
| 10. Install the window in the following order: a. install windows through the opening in the inner door panel; b. windows tighten nuts;
Torque: 9-13 N ??? m
c. Connect the window motor electrical connector. |
| 11. Position the window in the following order: a. Insert the outside of the door at first a forward part of the glass, and then, turning and lowering, set the glass on the door and place it on the bracket window; |
b. screw, but do not tighten definitively bolts of glass; c. reconnect the power window control switch; d. connect the wire to the negative terminal of the battery; e. Switch on the ignition and move the window up and down to activate the window control; f. if necessary, adjust the position of the glass; g. switch off the ignition; h. disconnect the wire from the negative terminal of the battery; i. tighten the two screws on the glass to the window;
Torque: 9-13 N ??? m
j. tighten a bolt of glass; Torque: 9-13 N ??? m
k. connect the wire to the negative terminal of the battery; I. Switch on the ignition; m. Move down the glass; n. switch off the ignition; o. disconnect the wire from the negative terminal of the battery; p. remove the window switch. |
12. Install the door pylevlagozaschitnuyu film in the following order: a. secure pylevlagozaschitnuyu film on the door; b. output wiring harness electrical connector door; c. output thrust of the internal handle of opening of the door lock pylevlagozaschitnoy film. |
| 13. Install the inside door handle in the following order: a. Connect to handle two thrust the door lock; b. attach the handle with three screws.
Tightening torque: 3-4 N ??? m |
| 14. Install the speaker and secure it with three screws. |
15. Establish an arm of the handle and secure it with one screw. |
16. Install the door trim. |
17. Install the inside door handle cover and secure it with one screw. |
| 18. Fix the door trim. |
19. Establish an internal moisture proof strip. |
20. Connect the cable to the negative terminal of the battery. |