REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Sephia / Shuma (1995 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Sephia / Shuma
		Maintenance
		Engine
		Greasing system
		Cooling
		The power supply system and release
		Fuel system
		Ignition system
		Coupling
		Manual transmission
			Technical data
			Checking the oil BF DOHC
			Checking the oil TE DOHC
			Change of oil
			Replacement of an oil sealing ring
			Removing and installing transmission
			Dismantling, check and assemblage of the fifth / reverse gear and back cover BF DOHC
			Dismantling, check and assemblage of the fifth / reverse gear and back cover TE DOHC
			Carter couplings and components of the gearbox BF DOHC
			Carter couplings and components of the gearbox TE DOHC
			A primary shaft of transmission BF DOHC
			A primary shaft of transmission TE DOHC
			A secondary shaft of transmission BF DOHC
			A secondary shaft of transmission TE DOHC
			Selecting shims
			Differential
			The gear change mechanism
		Automatic Transmission
		Axes and power shafts
		Steering
		Wheels and tires
		Brakes
		Suspension
		Body
		The air conditioning system
		Electrical equipment

Replacement of an oil sealing ring

PERFORMANCE ORDER

1. Lift the car and fix on support.
2. Remove the oil drain plug located at the end of the transmission and drain the oil into a suitable container.
3. Remove the front wheel.
4. Remove the mudguard.
5. Remove the front stabilizer bar from the lower arm.
A warning Do not damage dustproof covers.
6. Remove the coupling bolt, mount wring out the bottom lever downwards and separate a pin of the hinge from a rotary fist.
	7. Remove the nut and pin puller OK130283021 squeeze rod end from the steering knuckle.
A warning Do not damage the constant velocity joint (CV joint) the separation of the drive shaft of the transmission.
8. Insert mount between an internal SHRUS drive shaft and a transmission and easy blow on mount, remove the drive shaft of the transmission.
	9. To avoid damaging the outer CV joint drive shaft, a cord tie up a power shaft.
	10. An edge of a flathead screwdriver, remove the O-ring out of the slot transmission.
A warning Clear a nest of a sealing ring and put on a thin layer of oil. Grease a working edge of a sealing ring of the new oil.
	11. Using a mandrel OK201 170 AA1, establish a new sealing ring in a nest gearbox housing.
	12. Replace the retaining ring on the inner end of the drive shaft and insert the drive shaft in the gearbox, with the cut of a lock ring should settle down from above.

« previos page
Change of oil