REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz E-Class W123 (from 1976 to 1985, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mercedes-Benz
	W123
		Introduction
		Gasoline engines
		Coupling
		Manual transmission
		Automatic Transmission
		Driveline and rear axle
		The front suspension
		Rear suspension
		A steering
			Design and specifications
			Removing and installing steering wheel
			Removal and installation of the coupling shaft and a deformable steering column
			Removal and installation of the lock of a steering column lock
			Removal, dismantling and installation of the steering without power steering
				Removing, dismantling and installation of the idler arm
				Removal and installation of longitudinal and transverse steering rod
				Check and replacement of joints Tie Rod End
			Removal and installation of the mechanism of power steering
			Removal of air from hydraulic steering
			Removing and installing power steering pump
			Check and adjustment of corners of installation of forward wheels
		Brakes
		Electrical
		Body and Equipment

Removal and installation of longitudinal and transverse steering rod

PERFORMANCE ORDER

Apply the parking brake and post the front of the vehicle on supports (stands). Remove the wheels.
Remove the cotter pin and loosen the nut.
Stripper of the levers Extract the ball studs. In case of withdrawal of the longitudinal traction disconnect shock. Note the position of washers and covers.
Install in reverse order of removal. Check the front wheels.