REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz G-Class (W463, 1999 issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mercedes-Benz
	G-class
		Introduction
		Controls and operation receptions
		Current care and maintenance
		Engine
		System of cooling, heating, ventilation and air conditioning
		The power supply system and exhaust
		Systems of an electric motor
		Automatic Transmission
		Transmission Line
		Brakes and auxiliary systems
		Suspension and steering
		Body
			Specifications
			Outdoor equipment and body parts
			Salon Equipment
				Removal and installation of the lower lids dashboard
				Removal and installation of the instrument panel vents ducts
				Removal and installation of the glove compartment
				Removing and installing handle dashboard
				Removing and installing front ashtray
				Refitting the lower left section of the instrument panel trim
				Removal and installation of the knee fully
				Removal and installation of the end cap of the steering column
				Removal and installation of wall panel sections of the dashboard console
				Removing and installing center console
				Removal and installation of the instrument cluster
				Removal and installation of the instrument panel
				Removal and installation of salon mirrors
				Removing and installing panels finish touring racks
				Removing and installing trim panels
				Removal and installation of ceiling upholstery (Universal model)
				Removing and installing panels carpeting
				Removing and installing front seat assemblies
				Removing and installing rear seat assemblies
				Removal and installation of seat backs
				Removal and installation of seat cushions
		Onboard electric
		Wiring

Removing and installing rear seat assemblies

Details of installation of rear seat assembly


1 - Plugs 2 - Rear bolts 3 - Front bolts 4 - Console 5 - gas-filled damper 6 - Assembly pliers	H54 / 23 - Connector wiring left seat H54 / 24 - Connector wiring right seat

PERFORMANCE ORDER

Remove the decorative caps (1).
On models corresponding complete set (code H11) Disconnect connectors (H54 / 33 and H54 / 24) electrical heating seats.
Remove the bolts (2) and by means of special pliers (6), disconnect the gas-filled dampers (5) - stops at a detachment must be unloaded.
Release and remove the front screws (3).
Remove the rear seat.
If necessary, remove the console (4).
Installation is in the reverse order.