printable version

Removing and installing panels finish touring racks

And Racks

Details of installation of panels finishing racks A

1 - The seal of the door opening	2 - Finishing panel

Racks In

Convertible models

Details of installation of panels finishing stands in the Cabriolet models

1 - finishing plate racks 2 - Upper side finishing panel 3 - Guide the upper bracket assembly seat belt anchor 4 - Protector	5 - Ceiling finishing panel 6 - Coverage of cellular rubber 7 - connector signal buzzer reversing (BA) Arrow - Floating Cover

PERFORMANCE ORDER

Remove the side panel trim (see. Section Removing and installing trim panels). Release the lock rivet fastening the trim panel (1) in the bottom of the rack B. Removing beneath the cladding frames fixing screws, remove the upper handle. Unleashing the corresponding edge of the door seal, remove the top side finishing panel (2). Releasing below the lid facing the nut, remove the guide bracket (3) a seat belt. Remove the protector (4) on both sides of the roof paneling (5). Remove the cover (5). On models corresponding complete set (code J44) release the porous-rubber coating (6) and disunite a socket (7) of the ultrasonic sensor wiring signaling device BA (only on the right front). Release of the bodywork opening in the area of the rack in the door seal. Remove the protector (4) from the back of the rack B. Gently release the tab, remove the slotted cover (arrow) and release of her seat belt. Remove the panel (1) finishing stand. Installation is in the reverse order.

Touring Models

Details of installation of panels finishing stands in the Touring models (1 of 4)

1 - finishing plate

Details of installation of panels finishing stands in the Touring models (2 of 4)

2 - Plug

Details of installation of panels finishing stands in the Touring models (3 of 4)

3 - Anchor bolt

Details of installation of panels finishing stands in the Touring models (4 of 4)

5 - Gadget guide bracket assembly of the upper belt anchorage

The rear rack (Universal model)

Corresponding illustrative material is presented in the illustration details the installation of the tailgate on the Estate models and interface. illustrations, which include all the links in the text.

Installation Details panel trim C-pillar left

1 - Protector 2 - Finishing panel H4 / 7h2 - Left rear speaker	H4 / 8h2 - Right rear speaker

PERFORMANCE ORDER

On models corresponding complete set (codes V53 and V57), remove the luggage compartment cover (A). On models corresponding complete set (code V53) Remove the cover (B) of the side storage compartment, then turn the mounting screw (D) and separate storage compartment (C) from the back of the rack. Remove the rack from the back protector (1) the edge of the doorway. By submitting to the side, remove the finishing panel (2) rack - do not forget to disunite connector wiring speaker (H4 / 7h2 or H4 / 8h2). On models corresponding complete set (code J44) Disconnect the wiring connector of the signaling device BA (only on the right front). Remove the cover (2). Installation is in the reverse order.