REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Sunny (from 1991 to 1997, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Nissan
	Sunny
		Instructions
		Maintenance
		Engines
		Cooling
		Heating and ventilation system
		Fuel and exhaust system
			Carbureted engines
			Engines with fuel injection system
			The power supply / exhaust
				Models with one-point electronic fuel injection
				Models with multi-point electronic fuel injection
					Specifications
					Air filter
					An accelerator rope
					The accelerator pedal
					Fuel Injection System
					Fuel system
					Fuel pump
					Fuel Level Sensor
					Fuel tank
					Throttle Body
					Elements of the fuel injection system (engines of 1.6 liters)
						The fuel manifold and fuel injectors
						Fuel pressure control
						Throttle potentiometer
						Additional air valve
						Air Flow Sensor
						The solenoid valve of the engine fast
						Temperature Valve rapid engine warming
						Sensor crank angle and the power transistor
						Coolant temperature
						Electronic engine control unit
						The switch of neutral transfer
						The switch of blocking of a starter / reversing light
						Relay electronic engine control unit and the fuel pump
						The switch in the steering gain
						Switch the air conditioning system
						Speed sensor
					Elements of the fuel injection system (engines of 2.0 liters)
					Intake manifold
			Emission of exhaust gases
		The system of the engine is started
		Coupling
		Transmissions
		Axles
		Brakes
		Suspension and steering
		Body
		Electrical

printable version

Additional air valve

Connector additional valve Fuel

1. Connector additional valve Fuel

2. Loosen the screws

Additional air valve located in front of the throttle body.

Before his removal, disconnect the negative battery terminal.

Refitting

PERFORMANCE ORDER

1. Disconnect the connection from the solenoid valve.

2. Unscrew the two screws, then remove the valve from the throttle body and gasket.

3. If necessary, after removing the valve, remove the screws and separate the two halves of the valve. Make sure the valve plug is easily and quickly went back to the original position under the influence of spring. If not, the valve must be replaced.

4. Installation is spent upside-down removals. At installation use a new gasket.

« previos page
Throttle potentiometer

next page »
Air Flow Sensor