1. Before removing the airbag, follow these steps. |
2. Turn off the ignition and remove a wire of weight from the accumulator. When removing the wire of weight from the battery in the car should not be people. |
3. Isolate wire connectable to a negative terminal of the battery, in order to avoid accidental connection of wires. |
4. Remove the single-contact electrical connector for the power supply to the airbag system. |
5. Install the front wheels for movement directly forward. At the same time the steering wheel should be established in the middle position. |
A warning Failure to comply with the above requirements may result in failure of the airbag system.
|
6. Turn the steering wheel 90 ?� counterclockwise. |
| 7. Unlock the steering column. |
8. Move the steering wheel all the way over and down. |
9. Lock the steering wheel. |
10. Release the airbag, for which the back side of the steering wheel, insert the screwdriver blade length of 175 mm in the hole of the steering wheel (see. Figure. Releasing the airbag in the steering wheel with three spokes and rice. The release of the airbag in the steering wheel with four spokes) . |
11. Move the handle of the screwdriver upward (arrow) (see. Figure. Releasing the airbag in the steering wheel with three spokes and rice. The release of the airbag in the steering wheel with four spokes) blade screwdriver press down the retainer 9 and release the locking clip 3 airbags . |
12. Move the airbag from the steering wheel. |
13. Turn the steering wheel to 180 ?� clockwise and release the same way from the second airbag retainer clip. |
14. Install the steering wheel to the center position. At the same time the wheel will be mounted for rectilinear movement. |
15. Remove the single-contact electrical connector airbags. |
16. Remove the airbag. |
17. Do not change the position of the steering wheel. |