add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Golf IV (1997 release)

general info. full specifications. diagnostics. hints. tips. tricks
Volkswagen Golf 4
Home
 
Volkswagen
Golf 4
Instructions
Engine
Cooling system
Fuel System
Exhaust system
Ventilation and heating system
Removal and installation of the air nozzles
Installation of the lever central flap
Removal and installation of the fan heater and the additional resistor
Removal and installation of cables of management by heating and ventilation system
Shutter, regulating temperature of air submitted to salon
Removing and installing heater controls
Ventilation of the passenger compartment
The executive engine of the valve recycling air
The air conditioning system
Brackets C compressor
Coupling
Transmission
Suspension brackets and power shafts
Steering
Wheels and tires
Brakes
Body
Electrical equipment and wiring
 


Hit Counter by Digits


print page printable version

Removing and installing heater controls



Using a special device 3370 for removing a decorative panel heater controls


Location screws heater controls

Fixing screws are indicated by arrows.

Test ride control cables

Hold the cable cover, move the cable back and forth in the direction of the arrows.

Withdrawal

PERFORMANCE ORDER
1. Remove the glovebox.
2. Remove the lower steering column trim.
3. Remove the front section of the center console.
4. Remove the decorative panel heater controls. To remove the bezel can use special device 3370 (see. Fig. Using special tool 3370 for removal of the decorative panel heater controls) or a steel plate with a hook at the end, the same as for the removal of the central air supply nozzles.
5. Remove the four screws securing the unit heater control (see. Fig. Arrangement of screws securing heater controls).
6. Pull over, pull the heater control unit of the instrument panel together with the cables connected to it controls.
7. Disconnect the control cable from the heater controls.
8. Check the smooth running control cables, which hold a cable cover, move the cable back and forth (see. Fig. Check ride control cables).

Setting

Installing the cable management arm heater controls

1 - control cable;

2 - the lever heater controls

For easier identification envelope control cables have a different color.

PERFORMANCE ORDER
1. Put the rounded ends of the rope (1) on the control lever (2) and secure them by turning in the direction of the arrow.
2. To fix the sheath control cable, insert the cable holder (1) into the retainer (2) until it clicks into the holder of a cable.
3. Insert the control unit with the cables connected to the instrument panel.
4. Screw the four screws that secure the heater controls.
5. Insert the trim panel of the control unit to clear its locks.
6. Fit the front section of the center console.
7. Install the lower steering column trim.
8. Install the glove box.




« previos page
Refitting
next page »
Ventilation of the passenger compartment

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.