Replacing pulse rear wheel brake

The procedure should be followed:

1) Remove the caliper and the brake disk rear wheel in this order:

- The hub cap and the wheel;

- brake pads;

- The brake hose from the holder;

- Holder of a support assembly with a caliper; hang it on a steel wire in order to avoid damage to the brake hose;

- Unscrew the mounting bolt and remove the brake disc;

2) remove the wheel hub, unscrewing the nut;

3) remove the impulse wheel, removing two screws;

4) Clean the hub and set the pulse wheel. Tighten the bolts to 25 Nm;

5) Clean the pin and the hub, install the hub, set a new nut and tighten it to a torque of 177 Nm;

6) Clean and put a brake disk. Tighten the bolts to 8 Nm.

g) set the caliper brake hose wheel.

7) Check the operation of ABS:

- Read the fault codes;

- Perform a road test and check whether the indicator light turns off ABS;

- Check whether the fault codes registered.