printable version
Check the pressure in the hydraulic control lever
Warm up the automatic transmission to normal working temperature of the oil (ATF). Lift up the vehicle so that the front wheels to hang out.
| Fig. 3.69. Plugs for checking the pressure in the hydraulic system
|
Set check the tachometer to measure the speed of the crankshaft of the engine so that his testimony could easily count. Connect gauge and adapter (09452-21002 and 09452-21500) to the appropriate holes for pressure testing. When checking the pressure reverse gear (reverse pressure) should use a manometer 3000 kPa.
Measure the oil pressure in the automatic transmission (ATF) in each line under different conditions (Fig. 3.70). Check the measured values of a range of nominal values below in Table 3.16. If the measured pressure is outside the range of nominal values, test and repair according to the table 3.17.
|