add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Jeep Grand Cherokee (from 1993 to 1999, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Jeep Grand Cherokee
Home
 
Jeep
Grand Cherokee
Introduction
Adjustment and routine maintenance
The straight six-cylinder engine
The V8 engine
Procedure of the general and engine major repairs
Systems of cooling, heating and air conditioning
The power supply system and exhaust
The system of electric motor
general information
Starting the engine from the auxiliary power
Check and replacement of wires of the battery
Removing and installing battery
Ignition System - general information
Check of serviceability of functioning of the ignition system
Check of serviceability and replacement of the ignition coil
Check of serviceability and replacement of the camshaft position sensor
Removal and installation of the distributor
Charge system - the general information and precautions
Check of serviceability of functioning of charge
Removing and installing the generator
Starting system
Troubleshooting starter without removing it from the car
Removing and installing starter
Removal and installation of the traction relay (engines of 4.0 liters)
Systems of decrease in toxicity of the fulfilled gases and engine management
Manual box of a gear change
Automatic Transmission
Transfer Case
Clutch and transmission line
Brakes
Suspension and steering
Body
The system of on-board electrical equipment
Controls and operation receptions
 


Hit Counter by Digits


print page printable version

Removing and installing starter



PERFORMANCE ORDER

  1. Disconnect the negative wire from the battery.

If the radio in your car is equipped by a security code before to disconnect the battery negative cable, make sure that you know this code.

  1. Clearly label the wires and disconnect them by pulling the starter relay terminals. Release the wire from the clips, clamps on the starter housing.
  1. Disconnect the electrical connectors on the traction relay of a starter.
  1. Give fixing bolts and remove the starter.

Fasteners starter.

  1. Install in reverse order.




« previos page
Troubleshooting starter without removing it from the car
next page »
Removal and installation of the traction relay (engines of 4.0 liters)

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.