REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Sephia / Shuma (1995 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Sephia / Shuma
		Maintenance
		Engine
		Greasing system
		Cooling
		The power supply system and release
		Fuel system
		Ignition system
		Coupling
		Manual transmission
		Automatic Transmission
			Check of work and adjustment of position of the selector lever
			Check of level and liquid replacement in an automatic transmission
			The procedure for replacing the liquid in the converter of an automatic transmission
			Leaks of a liquid from an automatic transmission
			Replacement of oil sealing rings
			The unit control valves
			Radiator cooling automatic transmission fluid
			Removing and installing automatic transmission
			Repair of an automatic transmission
			Oil pump
			The body of the control valve
			The switch O / D
			Switch range gearbox
			The temperature sensor of an automatic transmission
			Speed sensor at the input / turbine
			Speed sensor
			Solenoid valves
			The linear solenoid valve
			Lever
			Repair of the selector lever
		Axes and power shafts
		Steering
		Wheels and tires
		Brakes
		Suspension
		Body
		The air conditioning system
		Electrical equipment

printable version

Radiator cooling automatic transmission fluid

Radiator cooling automatic transmission fluid:

1 - a washer;
2 - connecting bolt;
3 - inlet hose automatic transmission fluid (colder hose);
4 - output fluid hose automatic transmission (hotter hose);

5 - inlet tube automatic transmission fluid (colder hose);
6 - the output tube of a liquid of an automatic transmission (hotter hose);
7 - a radiator

Withdrawal

PERFORMANCE ORDER

1. Lift the car and fix on support.

2. Remove the seven screws and remove the right mudguards of a motor compartment.

3. Establish under a radiator the pallet for liquid gathering.

4. Disconnect the inlet and outlet hoses, automatic transmission fluid.

5. Remove the inlet and outlet tubes of a liquid of an automatic transmission.

6. Remove the heat sink (see. Subsection 4.12).

Usanovka

PERFORMANCE ORDER

1. Install the heat sink (see. Subsection 4.12).
2. Set the input and output tubes automatic transmission fluid. Torque: 32-47 N ??? m
3. Slide the inlet and outlet hoses for automatic transmission fluid tube forehand so that the ends of the hoses have reached fillets on tubes.
4. Install the hose clamp on the hose in the center of marks and under the corner shown in the figure.
	5. Check that the hose clamp does not touch any other parts.
6. Install the right mudguards of a motor compartment and fix seven screws.
7. Lower the car.
8. Check the fluid level in automatic transmission.

« previos page
The unit control valves

next page »
Removing and installing automatic transmission