1. Install the control valves, secure the eight screws and clamps wires. Length of bolts: A - 30 mm - 50 mm The inhaling moment: 7,9-10,7 N ??? m |
2. Install the oil strainer and tighten the three screws. The inhaling moment: 7,9-10,7 N ??? m |
3. Connect all the electrical connectors. |
| 4. Clean the mating surface of the oil pan and transmission case from the remnants of old gasket. Install sump with a new gasket and tighten bolts nineteen. The inhaling moment: 8,4-10,7 N ??? m |
5. Establish a plate of protection of the engine and freely screw bolts and nuts. |
| 6. Tighten the nuts and bolts A mounting plate in the engine protection. Torque: A - 38-51 N ??? m B - 48-65 N ??? m |
7. Install the left and right mudguards of a motor compartment and fix seven screws each. |
8. Remove special adaptation OK201 170 AA0 supporting the engine. |
9. Remove the dipstick and fill with fluid required amount of liquid required. Check the fluid level in an automatic transmission with the engine at idling speed. |
10. Spend a control trip and check for leaks in the places mentioned above. |