 printable version
Replacement of the fuel tank and the filler pipe
If fuel leaks from the tank is recommended to replace the tank. If the mesh is often clogged fuel pump, remove and rinse the tank. You will need: face head "14", an extension cord, knob-nose pliers. 1. Place the vehicle on a lift or a viewing ditch. |
3. Disconnect a wire from the plug ?�-?� the storage battery. |
| | 5. Loosen the hose clamp to the pipeline system EVAP, squeezing it with pliers bent antennae. Slide the clamp on a hose ... | 6. ... and disconnect the hose from the pipe. |
| | 7. Loosen the hose clamps the hose to the fuel tank filler pipe 1 and disconnect the hose from the tank nozzle. In a similar way to disconnect the hose 2 tank ventilation. | 8. Install a tank support. |
| | | 10. Remove the two screws securing the fuel tank brackets ... |
| | 11. ... and move the brackets to the side. | 12. Inspect the protective rubber gasket mounting brackets of the fuel tank. If there are signs of aging of the rubber, replace them. |
| 13. Remove the fuel tank. |
HELPFUL ADVICE The fuel tank is rather cumbersome, so it is better to shoot with the assistant. |
| | 14. If necessary, remove the fuel tank brackets, moving their pins from the holes in the body panel. | 15. Loosen the hose clamp tank vent to his nipple, squeezing it with pliers bent antennae. Slide the clamp on a hose ... |
| | 16. ... and disconnect the hose. | 17. Hooking a screwdriver, remove the pipe fuel filler strainer. |
| | 18. Loosen the hose clamp on the fuel vapor recovery system to the nozzle valve, squeezing it with pliers bent antennae. Slide the clamp on a hose ... | 19. ... and disconnect the hose from the nipple. |
NOTE Since fixing screws are located valve system EVAP. |
| | 20. Remove the screws fixing the valve of system EVAP ... | 21. ... and remove the valve from the fuel tank. |
| 22. Remove the valve sealing rubber gasket. Inspect the gasket. If there are signs of aging rubber, replace it. |
NOTE It looks like the valve system EVAP: 1 - gasket; 2 - the valve; 3 - the pressure plate. |
| 23. When installing the gasket her mustache should enter into the hole of the pressure plate. |
NOTE So is bracket filler pipe of the fuel tank to the body panels. |
| | 24. If you need to remove the filler tube of the fuel tank, remove the bolt bracket filler pipe to the body panels ... | 25. ... the two screws to the side of the body ... |
| 26. ... and remove the filler tube with a sealing gasket and air tube. |
27. Install the fuel tank and the filler pipe in the reverse order of removal. |
28. Fill the fuel tank, start up the engine and check the tightness of all connections of fuel lines. |
|
