|
printable version
Removing and installing starter
Petrol models Withdrawal | - Disconnect the negative wire from the battery.
- Remove the two screws on the upper intake manifold support bracket.
- Post the car off the ground.
| - On models with Manual transmission remove the two mounting bolts and move aside the clutch slave cylinder.
|
- Remove the two lower mounting bolts and remove the intake manifold support bracket.
| - Remove the two top bolts of fastening of a starter.
|
- Remove the lower mounting bolt, release the starter from the dome of coupling (models with Manual transmission) / torque converter (AT model) and resting, lock it in the engine compartment.
- Lower the car to the ground.
- Top disconnect the wiring from terminal S starter.
| - Release the fixing nut and disconnect the wiring from the terminal B (1) starter - not dropped a lock washer.
|
- Again lift the car, move aside the electrical transmission and plait from the bottom, remove the starter from the engine compartment.
|
|
Setting | - Get a starter in the engine compartment.
- Lower the car to the ground and connect the wiring to the terminal in the starter - do not forget to put the lock washer, Track reliability of a tightening of the nut.
- Connect wiring to terminal S.
| - Keep a regular place on the intake manifold support bracket and secure it with the two upper screws.
|
- Lift the car and set up a starter on the regular place.
- Screw the first top two mounting screws, and then lower.
- Align the starter, then tighten the three fixing bolts with demanded effort (37 ÷ 54 Nm).
- Screw and tighten with demanded effort (37 ÷ 54 Nm) lower bolts intake manifold support bracket.
- On models with Manual transmission replace the clutch slave cylinder, - the effort of a tightening of fixing bolts and is 37 ÷ 54 Nm.
- Lower the car on the earth and tighten with demanded effort (37 ÷ 54 Nm) of the support bracket bolts upper intake manifold.
|
|
Diesel models Installation Details starter on diesel models | - Disconnect the negative wire from the battery.
- Remove the upper starter mounting bolts.
- Post the car off the ground.
- Disconnect the wiring from the terminals in the starter and S, - try not to lose lock washer when you release the mounting screws Terminal B.
- Remove the lower mounting bolts and remove the starter.
- Installation is in the reverse order, - check compliance with the requirements of Specifications of the Head of System of an electric motor to the efforts of a tightening of threaded fasteners.
|
|
|
|