|
|
 printable version
Removal and installation of the lever of switching of modes of a distributing box
| - Remove the two mounting screws, cock the parking brake lever and remove the rear section of the center console.
- Loosen the lock nut and remove the shift knob Manual transmission / selector AT and transfer case.
- Remove the three screws and remove the front section of the center console.
- Release the fixing nut / bolt, remove the mounting plate and remove the boot (s) of the lever of switching of modes and transfer case shift lever Manual transmission (on models corresponding complete set).
 | - Turn out fixing bolts and remove the lever (1) shift transfer case. Move aside planted on the front bolt lock wiring and remove the rear console.
|
- Inspect the arm for signs of wear of moving components, deformation and other mechanical damage. Check the condition of the spring and the sealing element. Visually assess the degree of wear visible elements of the drive shift transfer case. Defective components replace.
- Lubricate the seat surface of the base plate with silicone sealant lever and slide the lever assembly on the regular place - do not forget to put on the front bolt lock harness.
- The further installation is made in the reverse order of the dismantling of the components - track compliance Specifications Chapter Transmission Line to the efforts of a tightening of threaded fasteners.
|
|
|
|
