printable version
Device combination
Refitting Disconnect the negative battery terminal and drop down adjustable steering column.
| Fig. 13.42. Fasteners instrument cluster with switches: 1 - fixing screws switches; 2 - left control unit; 3 - the top casing; 4 - facing a combination of devices; 5 - right control unit; 6 - screw fixing switches; 7 - a combination of devices
|
| Fig. 13.43. Fasteners dash without switch: 1 - facing a combination of devices; 2 - the screw; 3 - a combination of devices; 4 - Connectors; 5 - backlight; 6 - screw fixing the instrument cluster
|
Unscrew the instrument cluster. Disconnect the speedometer cable. Pull the instrument cluster, disconnect the connector and remove a combination of devices and power switch from the instrument panel. Installation is performed in reverse order of removal.
Pointers Disconnect the negative battery terminal. Remove the instrument cluster. The instrument cluster of analogue type
| Fig. 13.44. The instrument cluster of analogue type 1 - back plate; 2 - the instrument cluster; 3 - coolant temperature and fuel level; 4 - frame; 5 - glass; 6 - screw fixing of glass; 7 - speedometer; 8 - a printed circuit board; 9 - the screw securing the printed circuit board
|
Remove the screws and remove the glass plate and the printed circuit board (Fig. 13.44). Turn out bolts and remove a combination of devices from the body. Installation is performed in reverse order of removal. A combination of devices such as digital Remove the lamp cartridges and remove the screws to remove the PCB from the housing.
| Fig. 13.45. Elements of electronic instrument cluster 1 - back plate; 2 - the screw of fastening of the bottom of the PCB; 3 - the bottom printed circuit board; 4 - the gauge of level of fuel; 5 - the screws that secure the glass; 6 - glass; 7 - tachometer and plate; 8 - coolant temperature sensor; 9 - speedometer; 10 - odometer; 11 - printed circuit board; 12 - the case of a combination of devices
|
Remove the tachometer and PCB. Remove the switch display. Remove the control knob and light. Remove the screws and disconnect the connector from the speedometer, fuel gauge and coolant temperature. Installation is performed in reverse order of removal. Replacement of a cable drive speedometer Remove the bolt and remove the cable and speedometer drive from the gearbox. Partially pull out the instrument cluster so as to obtain access to the rear of the instrument cluster. Disconnect the cable from the speedometer. Disconnect the cable from the fire wall and remove it from the engine compartment. Transfer all the sealing ring and, if necessary, the driven gear from the old to the new cable. Installation is performed in reverse order of removal. When installing, do not allow the formation of loops on the new drive of a speedometer cable and passes it through a narrow sleeve.
|