printable version
Wipers
Windscreen wiper Disconnect the negative battery terminal.
| Fig. 13.53. Windshield wiper 1 - Wiper; 2 - the nut and the wiper arm; 3 - Cover; 4 - bolt mechanism wipers; 5 - wiper mechanism; 6 - the bolt of the wiper motor; 7 - the wiper motor; 8 - grating
|
Unscrew the nuts and remove the wiper arms. Remove the cover grille and the base of the windscreen.
| Fig. 13.54. Use a screwdriver to separate the wiper motor from the mechanism
|
Remove the screws, disconnect the connector and remove the screwdriver to separate the wiper motor (Fig. 13.54). Remove the bolts and remove the wiper mechanism of the vehicle through the hole in the body. Installation is performed in reverse order of removal. Set the wiper arm so that the wiper blades are parallel to the bottom of the windshield.
Rear window wiper Disconnect the negative battery terminal.
| Fig. 13.55. Rear window wiper 1 - Wiper; 2 - the wiper arm; 3 - rubber seal; 4 - wiper motor; 5 - an arm
|
Lift the lever, disconnect and remove the brush and rubber seal (Fig. 13.55). Open the trunk and remove the upholstery. Remove the screws, remove the bracket and the wiper motor. Installation is performed in reverse order of removal.
Windscreen washer pumps
| Fig. 13.56. Headlights: 1 - a tank; 2 - pump; 3 - hoses; 4 - safety valve; 5 - jet; 6 - switch
|
All models mounted windshield washer pump. Depending on the installed equipment can be installed additional pumps for rear window washer and headlight washers (Fig. 13.56). Removing all the washer pump is similar. Drain as much fluid from the washer fluid reservoir and prepare cloth to collect fluid flowing when removed. Disconnect the pump hose and connector. Remove the pump by pulling it out of the tank (if it is installed in such a way), or by releasing the fastening clips. Installation is performed in reverse order of removal. Installation using new gaskets, and if necessary, the hoses.
|