printable version
Switches
Test drive adjustable in three directions Strut Suspension Uncover the damper actuator and disconnect the connector.
| Fig. 13.27. Pin (?�L?�, ?�in?�, ?�W?�) drive connector adjustable in three directions Strut Suspension
|
Ohmmeter measure resistance between contacts ?�L?� and "B" (sports mode) and contacts ?�W?� and "B" (normal mode) (Fig. 13.27). The resistance must be within 2.8-3.3 ohms.
Combination switch Disconnect the negative battery terminal. Remove the steering wheel. Loosen the screws and remove the upper and lower casings of a steering column. Remove the retaining ring of the ignition switch. Remove the backlight and the ignition switch (if necessary), tilt steering column lever. Loosen the clamp screw of the ignition switch. Lift installation tab combined switch, then pull the switch from the steering column. Disconnect the switch connectors. Installation is performed in reverse order of removal. Ignition Switch To access the ignition switch, remove the steering wheel and the combination switch. Drill out the mounting bolts of the ignition switch or unscrew them, turning using a chisel or core. When installing, you will need new bolts from the cutting head. Remove the ignition switch to the steering column and disconnect the connector. Turn the ignition back on and tighten bolts. Connect to the ignition switch connector, check the operation of the ignition switch and steering lock. After checking their work, tighten the bolts to cutting their heads. Set the combination switch and the steering wheel.
|