add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz E-Class W123 (from 1976 to 1985, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Mercedes-Benz W123
Home
 
Mercedes-Benz
W123
Introduction
Gasoline engines
Coupling
Manual transmission
Automatic Transmission
Driveline and rear axle
The front suspension
Rear suspension
A steering
Brakes
Electrical
Design and specifications
Removing and installing the battery
Topping up the electrolyte in the battery
Charging the battery
Technical obsluzhiva?�nie generator and special precautions
Removing and installing the generator
Check the vehicle alternator and voltage regulator
Removal, survey and installation of generator brushes
Removing and installing starter
Repair of starter
Fuses and relays
Removal and installation of the combination switch
Removing and installing the door switch of illumination of salon
Removing and installing light switch
Removal and installation of switches and dashboard console
Removal and installation of the instrument cluster
Removal and installation of a flexible shaft drive speedometer
Removing and installing dash panel indicators
Adjustment of headlights / fog lights
Removal and installation of lights and lamps
Replacing bulbs
Replacing windshield wiper blades
Removing and installing windscreen wiper arm
Removing and installing windscreen wiper drive
Removal and installation of the actuator rod wiper
Removing and installing drive cleaner lights
Windscreen
Schematic diagrams of electrical equipment
Body and Equipment
 


Hit Counter by Digits


print page printable version

Fuses and relays



The fuses are located in the engine compartment on the right at the walls of the body. Various relays are placed separately on the wiring harness. Fuses should always be replaced with new ones of the same value. Do not reuse the same fuse without knowing the cause of the fault (usually short). Before replacing the fuse, always switch off the ignition.

For access to fuses, remove the fuse box cover (two buttons). The fuses are inserted between the spring contacts. Chain protected by fuses, are indicated inside the cover, however, if necessary, can use the mounting diagrams in the end of this section.
Fuse supply line is the radio beside him. Relays are installed behind the instrument panel or in the engine compartment.





« previos page
Repair of starter
next page »
Removal and installation of the combination switch

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.