REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz E-Class W123 (from 1976 to 1985, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mercedes-Benz
	W123
		Introduction
		Gasoline engines
		Coupling
		Manual transmission
		Automatic Transmission
		Driveline and rear axle
		The front suspension
		Rear suspension
		A steering
		Brakes
		Electrical
			Design and specifications
			Removing and installing the battery
			Topping up the electrolyte in the battery
			Charging the battery
			Technical obsluzhiva?�nie generator and special precautions
			Removing and installing the generator
			Check the vehicle alternator and voltage regulator
			Removal, survey and installation of generator brushes
			Removing and installing starter
			Repair of starter
			Fuses and relays
			Windscreen
			Schematic diagrams of electrical equipment
		Body and Equipment

Removing and installing starter

Wire pulling the starter relay

PERFORMANCE ORDER

Jack up the front of the car and put it on the supports (stand). Apply the parking brake.
Disconnect the negative battery terminal.
Disconnect the wires from the traction relay. To do this, unscrew the nut, remove the power cord and undock from the terminal wires of the control circuit.
Remove the bolts from the starter to the intermediate plate and bracket, remove the starter, dropping him down. To loosen the upper bolts need a socket wrench.
Install the starter is made in reverse order of removal. All bolts wrapped his hands first, and then wrench tighten.