REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz E-Class W123 (from 1976 to 1985, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mercedes-Benz
	W123
		Introduction
		Gasoline engines
		Coupling
		Manual transmission
		Automatic Transmission
		Driveline and rear axle
		The front suspension
		Rear suspension
		A steering
		Brakes
			Design and specifications
			Checking and replacing the disc brake pads
			Removing, dismantling and installation of the brake caliper
			Inspection, removal and installation of a brake disk
			The main brake cylinder
			Hoses and pipes
				Flexible hoses
				Steel brake pipes
				The vacuum brake booster
				Removing and installing brake light switch
				Removal and installation of a pedal
			Parking brake
		Electrical
		Body and Equipment

printable version

Removal and installation of a pedal

If necessary, remove the lower part of the dashboard.
PERFORMANCE ORDER
Disconnect the pushrod from the brake pedal by removing the hinge pin and removing the sleeve.
Unhook the return spring.
Remove the spring clip and remove the pedal axle.
Installation is carried out in reverse order. Thus on the pedal shaft should apply a small amount of grease.

See. And the brake servo.

« previos page
Removing and installing brake light switch

next page »
Parking brake