printable version

Removal and installation of the gauge of VMT

TDC sensor (see. Photo in "order of execution")

1 - an arm 2 - Block 3 - TDC sensor

4 - sensor bracket 5 - pin pin 6 - Pattern

The template for the sensor TDC

PERFORMANCE ORDER

1 Remove the bracket from the box. Disconnect 2. Pull up the TDC sensor 3 of the bracket 4. Loosen the bracket screws 4. Put the template 6 (manufacture of the accompanying drawings) to the contact pin 5. Bring the TDC sensor completely into the template. In this position, tighten the bracket screws 4 (see. Above). When installing the sensor TDC provide a match mark FROM (TDC) on the flywheel of the engine with the tide on the timing cover.