Removal and installation of facing the outside rearview mirror

1. Set the outside mirror inside.
2. Disconnect the negative (-) cable of the battery when the ignition is off. You must first remove the air filter box of the passenger compartment. Before disconnecting the cable, find out the radio security code, if any, address to Section Replacement of the battery.

3. Press the mirror inside. To fix the mirror in this position, insert a piece of wood (1) length of about 10 cm and hold it. (2) - facing the exterior mirror. Models with electric mirrors fold mirror inside.

4. Use a screwdriver (1) release the retaining spring (2), while facing the mirror a little pull out and release it. Make sure that it does not squeezed out a piece of wood. The illustration shows the mirror is removed from the liner.

5. Remove the wooden bar and fold the mirror forward. Completely separate the liner from the mirror holder (3). It is necessary to disunite connector (4) Indicator.

1. Insert the lining of the mirror holder and fix it.
2. Click on the mirror back and forth and check for correct installation of the lining.
3. Connect the negative (-) cable to the battery when the ignition is switched off. Replace the cabin air filter box. Enter the code of the radio and set the time on the clock.
4. Check the operation of the turn signal.