Removal and installation of the jet washer windscreen

1. Open the hood.
2. Disconnect the negative (-) cable of the battery when the ignition is off. You must first remove the air filter box of the passenger compartment.

Before disconnecting the cable, find out the radio security code, if any, address to Section Replacement of the battery.

3. Remove the grille from the hood spoiler windshield, refer to Section Removal and installation of gratings spoiler.

4. Disconnect the connector (1) from the jet heater (2).

5. Remove the connecting element (3) a water hose from the jet (4).
6. Disconnect and remove the nozzles with a screwdriver out of the holder.

1. Insert the nozzles in a spoiler grille and lock.
2. Place the connecting element on the jet.
3. Dock connector heating the jet.
4. Install the grille spoiler, address to Section Removal and installation of gratings spoiler.
5. Connect the earth cable (-) battery when the ignition is switched off. Replace the cabin air filter box. If necessary, enter the code for the radio and set the time on the clock.
6. Close the hood.
7. Check the operation of the jet and adjust it, refer to the appropriate section.

See the accompanying illustration.