Removing and installing brake light switch

1. Turn off the ignition.
2. Remove the cover under the dashboard on the driver side.
3. Disconnect the connector of the brake switch (1).

4. Push the stopper (1), turn the switch to the right and pull it out of the holder.

1. Remove the plunger (2) of the new brake light switch until it stops. This creates a maximum stroke "a".
2. Fully press the brake pedal. Insert the switch and turn to the left so that the stopper (1) is fixed.
3. Release the brake pedal. This course is set pusher itself.
4. Dock connector of the brake switch.
5. Check whether the lamp lights stoplight with little pedal is depressed.
6. Replace the cover under the dashboard on the driver, refer to the appropriate section.