1. Depending on the model, fold the rear seat forward or remove it, refer to the appropriate section.
2. Remove the mat on the floor under the rear seat.  | The mat is pulled in the forward tilted seat back and under the rear door sill lining. |
3. Remove the cover of the adjusting device.
4. Fully release the parking brake and release the tension of the cable, refer to Section brake system checked. Adjusting the parking brake.  | 5. Disconnect the cables (1) and (2) of the adjusting device. |
6. Squeeze the plastic strip (arrows in the figure) at the end of the cable, and disconnect the cables in the passageways of the bottom of the body.  | 7. Disconnect the cable from the front pedal parking brake (1). Squeeze the plastic strip on the end of the rope and pull the cable out of the holder (2) on the pedal. |
8. Attach the supporting rope to the front end of the cable.
9. Mark a paint position of the rear wheels relative to the hub. This allows the assembly to establish BALANCED wheels in their former position. Loosen the wheel bolts before jacking the car. Lift the rear of the car, put it on supports and remove the rear wheels.  | Operation lifting and car installation on supports is connected with danger! Therefore, prior to the operation to check out the Poddomkrachivanie and towing Introduction to management. |
10. Remove the rear brake caliper, refer to the appropriate section.
11. Remove the brake disc rear brake, refer to the appropriate section.
12. Remove the brake pads of the parking brake, refer to the appropriate section
13. Disconnect the cable from the rear of the expander lock the parking brake drum.
14. Remove the screws and remove the engine compartment, address to Section Removal and installation of the engine compartment lid from the bottom.
15. Pull out the cables from the passages in the bottom, unclip and remove. | 
