REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz G-Class (W463, 1999 issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mercedes-Benz
	G-class
		Introduction
		Controls and operation receptions
		Current care and maintenance
		Engine
		System of cooling, heating, ventilation and air conditioning
		The power supply system and exhaust
		Systems of an electric motor
		Automatic Transmission
		Transmission Line
		Brakes and auxiliary systems
		Suspension and steering
			Specifications
			Front suspension
			Rear suspension
			Steering
				general information
				Check the steering pump pressure
				Check and adjustment of the hydraulic stop
				Adjusting the steering shaft
				Assessment of components of the steering gear
				Removing and installing steering wheel
				Removal and installation of the contact cable drum steering wheel
				Removing and installing steering angle sensor wheel
				Removal and installation of the mechanism of the electronic steering column lock
				Removing and installing steering column with electric adjustment
				Removing and installing the steering pump
				Removing and installing power steering fluid cooling line
				Removal and installation of the steering mechanism
				The design of the steering mechanism
			The suspension geometry
		Body
		Onboard electric
		Wiring

Adjusting the steering shaft

Adjusting the steering shaft


1 - Rod wrench (Allen) 2 - Lock nut	3 - Adjustment screw

PERFORMANCE ORDER

Extract the lateral thrust of the pitman arm (see. Section Removal and installation of the steering mechanism).
Release nut (2) on the steering shaft.
Turn the adjusting screw (2) of the shaft approximately 1/8 turn clockwise.
Several times turn a steering wheel from lock to lock.
Using a torque wrench to vote resistance to steering shaft rotation - maximum resistance should occur in a straight position. If the rotation resistance is insufficient (see. Specifications), arm Prutkov key (1) and tuck the adjusting screw (3) counterclockwise, otherwise turn the screw clockwise.
Having achieved the desired result, lock the screw (3) and tighten the lock nut (2).
Connect cravings bipod.